Single chip USB to asynchronous serial data transfer interface
Entire USB protocol handled on the chip - No USB specific firmware programming required
Fully integrated 2048 byte EEPROM for storing device descriptors and CBUS I/O configuration
Fully integrated clock generation with no external crystal required
Data transfer rates from 300 baud to 3 Mbaud
512 byte receive buffer and 512 byte transmit buffer with buffer smoothing technology
FTDI's royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers
Configurable CBUS I/O pins and transmit/receive LED drive signals
UART interface support for 7 or 8 data bits, 1 or 2 stop bits and various parity options
Synchronous and asynchronous bit bang interface options
Battery Charger Detection for faster charging of batteries
Device supplied pre-programmed with unique USB serial number
Supports bus powered, self powered and high-power bus powered USB configurations
Integrated +3.3V level converter for USB I/O
True 3.3V CMOS drive output and TTL input (5V tolerant)
Configurable I/O pin output drive strength
Integrated power-on-reset circuit and UART signal inversion option
Internal 3.3V/1.8V LDO regulators
Low operating current of 8mA (typical) and USB suspend current of 125uA (typical)
Low USB bandwidth consumption
UHCI/OHCI/EHCI host controller compatible
USB 2.0 Full Speed compatible
Extended operating temperature range: -40°C to 85°C
Available in compact Pb-free 16 Pin SSOP and QFN packages (RoHS compliant)
Your message must be between 20-3,000 characters!
English
